RDC error in the licensing protocol

Guest

I own 4 computers: 2 desktops and 2 laptops. I'm able to connect to
my job's Remote Desktop on 1 of the laptops and 1 of the desktops.
The other 2 give me the following error: "The remote computer
disconnected the session because of an error in the licensing
protocol. Please try connecting to the remote computer again or
contact your server administrator."
I have tried clearing out the MSLicensing keys in the registry and
verified that TermService is running. All of the computers are set up
exactly the same and are running XP Pro SP2. I need to get RDC
working on all of my computers and I am stumped as to how to resolve
this issue.

Thanks in advance for any help!

--
Justin

Google · Sponsor

Robert L. (MS-MVP) · Guest

Have you reboot the computer? If yes, can you telnet port 3389?

--
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on
http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on
http://www.HowToNetworking.com

<jakremer@gmail.com> wrote in message
news:1a3a5460-1ae3-45e8-952a-3da02435fb6c@b1g2000pra.googlegroups.com...

the.hole.k · Guest

Yes, I have rebooted the computer. Telnet to the server results in
the screen going blank and a flashing cursor...no error message.
I am able to pull up the Terminal Server web access page (IPaddress/
tsweb), but clicking on the Connect button results in an error: The
client could not establish a connection to the remote computer...
Remote Desktop is checked as an exception in Windows Firewall.

I have spent numerous hours troubleshooting this. I cannot figure out
what is different on my 2 machines that work just fine with this same
server!

Thanks for the reply, Bob.

--
Justin

On Dec 9, 11:09 am, "Robert L. \(MS-MVP\)" <nore...@chicagotech.net>
wrote:

Robert L. (MS-MVP) · Guest

Could that be a firewall issue? If you do safe mode or clean booting on both
computers (host and client) and then try it. does that work?

How to run Windows OS with a clean ...With MSCONFIG, you also can configure
a clean boot to disable common startup ... To perform a clean boot, please
follow these steps: 1) Run MSCONFIG.EXE. ...
www.chicagotech.net/netforums/viewtopic.php?t=57

windows recoverySafe Mode is a very useful tool, especially for booting
problem caused by hardware or software changes. If you experience some
difficulties to start windows ...
www.howtonetworking.com/wintroubleshooting.htm

--
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on
http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on
http://www.HowToNetworking.com

"the.hole.k" <jakremer@gmail.com> wrote in message
news:5f5c2c3f-c13d-45e0-a63f-7b06f4920613@p69g2000hsa.googlegroups.com...

the.hole.k · Guest

I get the same error message when Windows Firewall is disabled. All
of my computers are behind the same NAT router, so I know that isn't
the issue.
Can't connect through Safe Mode. On my laptop, I was getting this
error on a clean install of XP.

--
Justin

On Dec 11, 8:37 pm, "Robert L. \(MS-MVP\)" <nore...@chicagotech.net>
wrote: